Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2012 >> Compass Sport, 2.4 B, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 317 (Electronic Control Modules (Service Information)) >> Module, Park Assist >> Removal >> Removal

Module, Park Assist: Removal: Removal

WARNING: This page is about a different car, the 2012 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Park Assist Module
GC0100783Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Partially remove the trim from the right quarter inner panel to access the park assist module (2), which is located above and behind the right rear wheel house, forward of the D-pillar. Refer to PANEL, QUARTER TRIM, REMOVAL .
  3. Disconnect the two body wire harness connectors (4) from the park assist module connector receptacles.
  4. Remove the three plastic push-in fasteners (3) that secure the module to the right quarter inner panel (1).
  5. Remove the module from the right quarter inner panel.
scientia non olet · About Mike's Workshop Manuals