Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2012 >> Compass Limited, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (3.6L Engine (Service Information)) >> Engine Block >> Damper, Vibration >> Installation >> Installation

Damper, Vibration: Installation: Installation

WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Crankshaft Seal Surface
GC0144230Courtesy of CHRYSLER GROUP, LLC
  1. Apply a light coating of engine oil to the front crankshaft seal surface (1).
    Fig 2: Crankshaft Vibration Damper & Bolt
    GC0144222Courtesy of CHRYSLER GROUP, LLC
  2. Align the crankshaft vibration damper (1) to the flywheel key on the crankshaft and install the damper. Seat the damper on the crankshaft sprocket.
  3. Install and hand tighten the crankshaft vibration damper bolt (2).
    Fig 3: Crankshaft Vibration Damper & Vibration Damper Holder
    GC0144221Courtesy of CHRYSLER GROUP, LLC
  4. Hold the crankshaft vibration damper (1) with Vibration Damper Holder (special tool #10198, Holder, Vibration Damper) (2) and tighten the crankshaft vibration damper bolt to 40 N.m + 105° (30 ft. lbs. + 105°).
  5. Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
scientia non olet · About Mike's Workshop Manuals