Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2012 >> Compass Limited, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 720 (5.7L Engine (Service Information)) >> Engine Block >> Damper, Vibration >> Installation

Damper, Vibration: Installation

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
GC0144946Courtesy of CHRYSLER GROUP, LLC
  1. Position damper onto crankshaft.
  2. Using (special tool #10387, Installer, Vibration Damper), install the threaded rod (1) onto the crankshaft (2).
  3. Tighten the threaded rod (4) until it is seated to the face (3) of the crankshaft.
  4. Install the press washer, bearing, washer, and the press nut onto the threaded rod.
  5. Press the vibration damper on till seated.
    GC0143968Courtesy of CHRYSLER GROUP, LLC
  6. Install crankshaft damper bolt.
  7. Position the (special tool #10386, Holder, Vibration Damper) (2), onto the vibration damper (3).
  8. Tighten the bolt to the proper torque specification. Refer to TORQUE SPECIFICATIONS  .
  9. Remove the cardboard from radiator face.
  10. Install the cooling fan. Refer to FAN, COOLING, INSTALLATION, 5.7/6.4L SINGLE FAN .
  11. Install the serpentine belt. Refer to BELT, SERPENTINE, INSTALLATION, 5.7L/6.4L ELECTRONIC POWER STEERING .
  12. Refill the cooling system. Refer to STANDARD PROCEDURE .
  13. Connect the negative battery cable.
scientia non olet · About Mike's Workshop Manuals