Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2012 >> Compass Limited, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 712 (Vehicle Theft Security (Service Information)) >> Sensor, Intrusion Module >> Installation

Sensor, Intrusion Module: Installation

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
GC0146814Courtesy of CHRYSLER GROUP, LLC
  1. Position the intrusion sensors (1) and pigtail wire harness to the overhead console housing as a unit.
  2. Install the intrusion sensors into the receptacles in the overhead console one at a time. Grasp a sensor firmly, insert it fully into the rearward-facing receptacle on either side of the overhead console housing, then rotate it clockwise about 30 degrees to engage. Repeat for the sensor on the opposite side of the overhead console.
    GC0146812Courtesy of CHRYSLER GROUP, LLC
  3. Install the Intrusion Transceiver Module (ITM) (2) onto the overhead console housing. Refer to MODULE, INTRUSION, INSTALLATION .
  4. Connect the intrusion sensor pigtail wire harness connector (1) to the ITM connector receptacle.
  5. Install the overhead console into the headliner. Refer to CONSOLE, OVERHEAD, INSTALLATION .
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About Mike's Workshop Manuals