Sensor, Intelligent Battery (IBS): Installation
WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
multimedia:A supplement to the article is available.
NOTE:
DO NOT use a hammer to tap down the sensor. Use a post spreader to open the post if reusing the existing sensor.
NOTE:
Avoid IBS rotation during tightening of battery cable nut to avoid breakage if the IBS rotates in to the battery.
- Place the IBS onto the negative battery post and push the IBS down until properly seated on the cone of the post.
- Connect the negative battery cable to the IBS stud (1) and tighten to the proper specification. Refer to TECHNICAL SPECIFICATIONS .NOTE:
The negative battery has much higher torque than that of the pole clamp and can break IBS free if not stabilized when tightening.
- Tighten the IBS pole clamp (1) to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
- Install the two-pin connector (Power & LIN) (1). Make sure there is no stress on the wires .
- Install the components removed to access the battery. Refer to BATTERY, INSTALLATION .