Cover, Structural Dust: Installation: Installation
WARNING: This page is about a different car, the 2012 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - BOLT |
| 2 - BOLT |
| 3 - BOLT |
CAUTION:
The structural dust cover must be installed as described in the following steps. Failure to do so may cause severe damage to the cover.
- Position the structural cover in the vehicle.
- Install all bolts (1) retaining the cover-to-engine. DO NOT tighten the bolts at this time.
- Install the cover-to-transmission bolts. Do NOT tighten at this time.CAUTION:
The structural dust cover must be held tightly against both the engine and the transmission bell housing during the tightening sequence. Failure to do so may cause severe damage to the cover.
- Starting with the two rear cover-to-engine bolts, tighten bolts (1) to 54 N.m (40 ft. lbs.), then tighten bolts (2) and (3) to 54 N.m (40 ft. lbs.) in the sequence shown in illustration. Refer to Fig 1.