Control Valve, Oil Intake: Installation: Installation

WARNING: This page is about a different car, the 2012 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing OCV

Courtesy of CHRYSLER GROUP, LLC

Lubricate the oil control valve (OCV) rubber O-ring seal with clean engine oil.
Install the OCV and rotate into position.

Fig 2: Oil Control Valve, Electrical Connector & Retaining Bolt
Courtesy of CHRYSLER GROUP, LLC
Install the OCV (3) retaining bolt (2) and tighten to 11 N.m (8 ft. lbs.).
Connect the OCV electrical connector (1).
Install the intake manifold. Refer to MANIFOLD, INTAKE, INSTALLATION, 5.7L .