Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2012 >> Compass Limited, AWD, Automatic CVT, CVT2L >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Continuously Variable Transmission (CVT) (Service Information) >> Cable, Shift Interlock >> Removal >> Removal

Cable, Shift Interlock: Removal: Removal

  1. Disconnect the battery.
    Fig 1: Shifter Bezel
    GC0099067Courtesy of CHRYSLER GROUP, LLC
  2. Remove the shifter bezel (1).
    Fig 2: Counsel Screws
    GC0084600Courtesy of CHRYSLER GROUP, LLC
  3. Remove the screws (1) at the console.
    Fig 3: Counsel
    GC0084601Courtesy of CHRYSLER GROUP, LLC
  4. Pull the console (1) back and remove electrical connector (2) (if equipped).
  5. Remove the console (1).
    Fig 4: Shifter Hold Down Bolts
    GC0084589Courtesy of CHRYSLER GROUP, LLC
  6. Remove the bolts (1) at the shifter.
  7. Separate the shift interlock cable from the shifter.
  8. Remove lower shroud at steering column. Refer to SHROUD, STEERING COLUMN, LOWER, REMOVALSHROUD, STEERING COLUMN, UPPER, REMOVAL .
    Fig 5: Shift Interlock Cable AT Column
    GC0084368Courtesy of CHRYSLER GROUP, LLC
  9. Place the ignition switch in the ON position.
  10. Depress the clip on the shift interlock cable (2) and pull cable out of column (1).
  11. Remove the cable.
scientia non olet · About Mike's Workshop Manuals