Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2012 >> Compass Limited, AWD, Automatic CVT, CVT2L >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Battery System - Service Information) >> Retainer, Battery >> Installation >> Installation

Retainer, Battery: Installation: Installation

WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Battery Hold Down Clamp
GC0079993Courtesy of CHRYSLER GROUP, LLC
  1. Install the battery hold down clamp and bolt. Tighten the bolt to 4 N.m (35 in. lbs.).
  2. Connect the battery negative cable. Follow the battery reconnection procedure. Refer to STANDARD PROCEDURE .
  3. Install the rear compartment floor trim panel.
scientia non olet · About Mike's Workshop Manuals