Media Hub: Installation: Installation

WARNING: This page is about a different car, the 2015 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Media Hub & Storage Bin Opening

Courtesy of CHRYSLER GROUP, LLC

From inside the floor console rear storage bin, align and insert the media hub housing (1) through the floor console storage bin opening (2) until the integral latch features are fully engaged on the back of the storage bin.

Fig 2: Media Hub & Connectors
Courtesy of CHRYSLER GROUP, LLC
From the underside of the floor console, connect the console wire harness connectors (2) to the media hub (1).

Fig 3: Rear Duct & Screws
Courtesy of CHRYSLER GROUP, LLC
Position the floor console rear duct to the two locating pins (2). Install the two screws (3) for the floor console rear duct (1) and securely tighten the screws.

Fig 4: Switch/Power Outlet Panel & Connectors
Courtesy of CHRYSLER GROUP, LLC
Connect the four wire harness connectors (1) to the switch/power outlet panel (2).

Fig 5: Floor Console & End Cap
Courtesy of CHRYSLER GROUP, LLC
Position the console end cap (1) and push the retainers into the floor console (2).
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.