Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2012 >> Compass Latitude, 2.0 A >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Battery System - Service Information) >> Sensor, Intelligent Battery (IBS) >> Installation >> Installation

Sensor, Intelligent Battery (IBS): Installation: Installation

WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Negative Battery Cable Retainer, Electrical Connector & Captive Nut
GC0144694Courtesy of CHRYSLER GROUP, LLC
NOTE:

Connecting the negative battery cable to the Intelligent Battery Sensor (IBS) must be done before installing on the battery post.

  1. Connect the negative battery cable to the IBS (1).

    Tighten to 16 N.m (12 ft. lbs.).

  2. Install the IBS on the negative battery post.
  3. Tighten the captive nut (3) to 8 N.m (72 In. lbs.).
  4. Connect the IBS electrical harness (2) to the IBS.
  5. Install the components removed to access the battery. Refer to BATTERY, INSTALLATION .
scientia non olet · About Mike's Workshop Manuals