Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2011 >> Wrangler Unlimited Sahara, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Electronic Control Modules (Service Information)) >> Module, Body Control >> Removal >> Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2011 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Glove Box Assembly & Push Panel
GC0144626Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the glove box assembly (1). Refer to GLOVE BOX, INSTRUMENT PANEL, REMOVAL .
  3. Remove the two push-pin type retainers and remove the lower hush panel (3).
    Fig 2: Clip & Fuse Box Assembly
    GC0147650Courtesy of CHRYSLER LLC
  4. Release the clip (3) and position the fuse box assembly (2) down.
  5. Disconnect the electrical connectors from the fuse box (4).
  6. Push the fuse box down and inward toward the floor. The top of the fuse box will roll back and release from the track.
    Fig 3: Body Control Module (BCM), Receptacles & Fasteners
    GC0144625Courtesy of CHRYSLER LLC
  7. Disconnect the electrical connectors from the Body Control Module (BCM) (1) receptacles (2 and 3) as needed.
  8. Remove the two fasteners (4) at the bottom of the module.
  9. Pull the module away from the side bulk head and down and remove the module.
  10. Remove the BCM from the vehicle.
scientia non olet · About Mike's Workshop Manuals