Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2011 >> Wrangler Sport, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Electronic Control Modules (Service Information)) >> Receiver, Keyless Ignition Node >> Removal >> Removal

Receiver, Keyless Ignition Node: Removal: Removal

WARNING: This page is about a different car, the 2011 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Bezel Assembly
GC0147717Courtesy of CHRYSLER LLC
  1. Disconnect the negative battery cable.
  2. Remove the switch-bank and bezel assembly (1). Refer to POD, SWITCH BANK, REMOVAL .
    Fig 2: Instrument Panel Center Bezel
    GC0147701Courtesy of CHRYSLER LLC
  3. Remove the instrument panel center bezel (1). Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL .
    Fig 3: Wire Connector, Clips & KIN
    GC0147718Courtesy of CHRYSLER LLC
  4. Disconnect the wire connector (1) from the Keyless Ignition Node (KIN).
  5. Push down on the release clips (2) (two on top and one on the bottom) and push the KIN (3) out the front of the instrument panel.
scientia non olet · About Mike's Workshop Manuals