Continuously Variable Transmission (CVT) (Service Information): Differential: Disassembly: Disassembly

Fig 1: Pin Punch AT Roll Pin

Courtesy of CHRYSLER LLC

1. Remove the roll pin using a pin punch (1).
   Fig 2: Pinion Shaft Roll Pin

   Courtesy of CHRYSLER LLC
2. Discard the old roll pin (3). Refer to Fig 2.
   Fig 3: Pinion Shaft

   Courtesy of CHRYSLER LLC
3. Remove the pinion shaft (2) and inspect for excessive ware. Refer to Fig 3.
   Fig 4: Pinion Gear Shim

   Courtesy of CHRYSLER LLC
4. Roll the pinion gears (3) and shims (1) out of the carrier (2). Refer to Fig 4.
5. Remove the pinion gear shims (1) and mark for installation.
   Fig 5: Pinion Gears

   Courtesy of CHRYSLER LLC
6. Remove the pinion gears (1) from the carrier (3). Refer to Fig 5.
   Fig 6: Side Gears

   Courtesy of CHRYSLER LLC
7. Remove the side gears (2) and shims (3) from the carrier. Refer to Fig 6.
   Fig 7: Remove Small Bearing

   Courtesy of CHRYSLER LLC
8. If the vehicle is a two wheel drive remove the carrier bearings using Puller (special tool #C-293-PA, Puller, Press), six Inserts (special tool #C-293-40, Block Set, Puller) and Press Insert (special tool #C-4996, Adapter, Plug).
   Fig 8: Remove Large Bearing

   Courtesy of CHRYSLER LLC
9. If all wheel drive use Puller (special tool #C-293-PA, Puller, Press), six (special tool #9613, Adapters, Puller) Inserts and Insert (special tool #8888, Plug, Differential Bearing) to remove the carrier bearings.