Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2011 >> Compass Base, 2.4 B, AWD, Automatic CVT, CVT2 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (2.0L Engine (Service Information)) >> Engine Block >> DAMPER, Vibration >> Removal >> Removal

DAMPER, Vibration: Removal: Removal

WARNING: This page is about a different variant/trim than selected.
Fig 1: Damper Removal & Installation
GC0084841Courtesy of CHRYSLER LLC
  1. Remove accessory drive belts. Refer to BELT, Serpentine, Removal .
  2. Install Damper holder (special tool #9707, Holder, Vibration Damper) (1).
  3. Remove crankshaft damper bolt.
  4. Pull damper off crankshaft.
scientia non olet · About Mike's Workshop Manuals