Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2010 >> Liberty Renegade, Part Time >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine Cooling System & Automatic Transmission Cooling System >> Engine >> BOTTLE, Coolant Recovery >> Installation >> Non-Pressure System

Non-Pressure System

Fig 1: Coolant Recovery/Washer Fluid Reservoir
GC0086435Courtesy of CHRYSLER LLC
  1. Position coolant recovery container (1).
  2. Install 5 screws, 3 on top, 2 on the outside lower edges of the resevoir (1 each side).
  3. Install two washer pump hoses, coolant recovery hose and washer pump electrical connector from the combination coolant recovery/washer fluid reservoir assembly (1).
  4. Connect negative battery cable.
scientia non olet · About Mike's Workshop Manuals