VALVE, Exhaust Gas Recirculation, 3.7L: Installation: Installation

Fig 1: LOCATING VALVE SOLENOID GASKET

Courtesy of CHRYSLER LLC

1. Clean gasket area (1) at rear of left cylinder head where it joins base of EGR valve.
2. Clean EGR tube where it joins EGR valve.
3. Position new gasket between EGR valve and cylinder head.
   Fig 2: LOCATING VALVE SOLENOID

   Courtesy of CHRYSLER LLC
4. Position EGR valve to cylinder head. Install and tighten two bolts (2). Tighten to 9 N.m (80 in. lbs.).
   Fig 3: EGR SOLENOID/TUBE ASSEMBLY

   Courtesy of CHRYSLER LLC
5. Position new gasket (3) between EGR tube flange and EGR valve assembly.
6. Position EGR tube (1) to side of EGR valve. Position end of tube (6) into intake manifold. Install two bolts (2). Tighten to 11 N.m (97 in. lbs.).
   Fig 4: LOCATING VALVE SOLENOID

   Courtesy of CHRYSLER LLC
7. Connect electrical connector (3) to top of EGR valve solenoid (1).
8. Connect negative battery cable.
9. Using a diagnostic scan tool, erase any previously recorded DTC's (Diagnostic Trouble Codes).