Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2009 >> Commander Overland, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Overhead Console (Service Information)) >> Overhead Console - Service Information >> Removal >> Overhead Console

Overhead Console

WARNING: This page is about a different car, the 2008 Jeep Commander. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Sunroof Instrument Panel
GC0065077Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the inside rearview mirror, refer to REMOVAL .
  3. Pull downward on the sides of the overhead console housing (3) firmly and evenly to disengage the snap clips from the overhead console bracket.
    Fig 2: Identifying Overhead Console Components (Rear View)
    GC0045539Courtesy of CHRYSLER LLC
  4. Lower the overhead console from the headliner far enough to access the wire harness connectors.
  5. Disconnect the roof wire harness connectors from the Electronic Overhead Module (EOM) (3) and combination power sunroof/liftgate switch (2) if equipped.
  6. Remove the overhead console from the vehicle.
scientia non olet · About Mike's Workshop Manuals