Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2008 >> Liberty Limited, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Steering System) >> Column >> Disassembly >> Steering Column >> Ignition Switch

Ignition Switch

WARNING: This page is about a different car, the 2008 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Ignition Switch Mounting & Screw
GC0042957Courtesy of CHRYSLER LLC
NOTE: Lock cylinder housing removed from column.
  1. Remove the ignition switch (2) mounting screw (1).
    Fig 2: Ignition Switch Removal/Installation
    GC0042958Courtesy of CHRYSLER LLC
  2. Pull the switch (1) straight out and off the retaining tabs (2) located on the lock cylinder housing.
scientia non olet · About Mike's Workshop Manuals