Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2008 >> Compass Limited, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Power Transfer Unit) >> Power Transfer Unit >> Seals-End Cover >> Installation >> End Cover Seals

End Cover Seals

WARNING: This page is about a different variant/trim than selected.
Fig 1: Install Carrier Cover Inner Seal
GC0056236Courtesy of CHRYSLER LLC
  1. Install the inner seal into the PTU cover using Installer 9852 and Handle C-4171.
    Fig 2: Install Carrier Cover Outer Seal
    GC0056237Courtesy of CHRYSLER LLC
  2. Install the outer seal into the PTU cover using Installer 9853 and Handle C-4171.
    Fig 3: Side Cover
    GC0056221Courtesy of CHRYSLER LLC
  3. Install the side cover.
  4. Tighten side cover bolts (1) to 23 N.m (17 ft. lbs.).
  5. Install the right halfshaft. Refer to INSTALLATION .
scientia non olet · About Mike's Workshop Manuals