Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2008 >> Compass Limited, AWD, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Power Transfer Unit) >> SEALS, End Cover >> Installation >> Installation

SEALS, End Cover: Installation: Installation

WARNING: This page is about a different car, the 2009 Jeep Patriot and 2009 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: INSTALL CARRIER COVER INNER SEAL
GC0084415Courtesy of CHRYSLER LLC
  1. Install the inner seal into the PTU cover using Installer 9852 and Handle C-4171.
    Fig 2: INSTALL CARRIER COVER OUTER SEAL
    GC0084416Courtesy of CHRYSLER LLC
  2. Install the outer seal into the PTU cover using Installer 9853 and Handle C-4171.
    Fig 3: SIDE COVER
    GC0084401Courtesy of CHRYSLER LLC
  3. Install the side cover.
  4. Tighten side cover bolts (1) to 23 N.m (17 ft. lbs.).
  5. Install the right halfshaft. Refer to Differential and Driveline/Half Shaft - Installation .
scientia non olet · About Mike's Workshop Manuals