Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2008 >> Commander Base, 4.7 N, AWD >> Repair and Diagnosis >> Engine Performance >> System >> DTCS U0001 To U1418, System Checks, Checking Pcm Power And Ground Circuits, Engine Cranks But No Start >> U110C-Lost Fuel Level Message >> Possible Causes

Possible Causes

Possible Causes 
CAN C BUS CIRCUIT OPEN OR SHORTED
FRONT CONTROL MODULE (FCM)
POWERTRAIN CONTROL MODULE (PCM)

Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding.

The fuel level signal is a direct input to the Cluster. The fuel level signal is sent to the FCM over the CAN B bus circuit. The NGC receives the fuel level signal from the FCM over the CAN C bus circuit.

scientia non olet · About Mike's Workshop Manuals