Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2007 >> Liberty Limited, 4WD, Part Time >> Repair and Diagnosis >> Accessories & Equipment >> Accessories Control Systems >> Overhead Console (Service Information) >> Installation >> Overhead Console

Overhead Console

Fig 1: Removing/Installing Overhead Console
GC0025601Courtesy of CHRYSLER LLC
  1. Position the overhead console (2) in the vehicle and connect the wire harness connectors.
  2. Connect the Electronic Overhead Module (EOM), courtesy lamps and power sunroof switch electrical connectors, if equipped.
  3. Grasp the sides of the overhead console (2) and push straight up evenly to engage the two snap clips at the rear of the unit.
  4. Install the overhead console retaining screw (3), located in the front of console near the windshield. Torque the screw to 1 N.m (10 in. lbs.).
  5. Connect the battery negative cable.
scientia non olet · About Mike's Workshop Manuals