Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2007 >> Compass Limited, FWD, Standard >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> T355 Manual Transmission >> T355 Manual Transaxle >> Cable-Gear Shift >> Removal >> Gearshift Cable Assembly

Gearshift Cable Assembly

Fig 1: CABLES AT TRANS
GC0056436Courtesy of CHRYSLER LLC
  1. Remove the shifter. Refer to REMOVAL .
  2. Raise hood.
  3. Remove the resonator.
  4. Remove engine cover.
  5. Remove air cleaner assembly.
  6. Disconnect both battery cables. Refer to REMOVAL .
  7. Remove battery hold down clamp and bolt, and remove battery.
  8. Remove battery tray. Refer to REMOVAL .
  9. Disconnect cables (1) from the shift levers at the transaxle (3).
    CAUTION: Pry up with equal force on both sides of shifter cable isolator bushings to avoid damaging cable isolator bushings.
  10. Squeeze cable retaining clips (2) and remove cables from bracket (4).
    Fig 2: CABLE CLIPS AT FLOOR PAN
    GC0056367Courtesy of CHRYSLER LLC
  11. Remove the Occupant Restraint Controller (ORC). Refer to REMOVAL .
  12. Remove shifter. Refer to REMOVAL .
  13. Squeeze cable retaining clips (2) and remove cables from bracket.
  14. Remove cable assembly (1) from vehicle.
scientia non olet · About Mike's Workshop Manuals