Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2007 >> Compass Limited, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (2.0L Engine (Service Information)) >> Cylinder Head >> Assembly-Variable Valve Timing >> Installation >> Installation

Assembly-Variable Valve Timing: Installation: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: CAMSHAFT PHASER
GC0054641Courtesy of CHRYSLER LLC
CAUTION: Do not use an impact wrench to tighten camshaft sprocket bolts. Damage to the camshaft-to-sprocket locating dowel pin and camshaft phaser may occur.
  1. Install phaser (2) assembly on camshaft.
    NOTE: Make sure the dowel is seated in the dowel hole and not in an oil feed hole. The dowel hole is larger than the 4 oil feed holes.
  2. Install phaser retaining bolt and tighten while holding camshaft in place with a wrench (1).
  3. Install camshafts. See INSTALLATION .
scientia non olet · About Mike's Workshop Manuals