Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2007 >> Compass Limited, AWD, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (T355 Manual Transmission) >> T355 Manual Transaxle >> Boot-Gear Shift >> Installation >> Gearshift Boot

Gearshift Boot

WARNING: This page is about a different variant/trim than selected.
Fig 1: SHIFTER KNOB MT
GC0056365Courtesy of CHRYSLER LLC
  1. Position gearshift boot (3) over the operating lever (2) and apply hand pressure to engage and snap console into place.
  2. Position gearshift knob (1) hole over the gearshift mechanism and align the shift pattern.
  3. Verify that shift pattern is aligned properly.
  4. Strike knob (1) with rubber mallet to engage knob to mechanism.
scientia non olet · About Mike's Workshop Manuals