Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2007 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (4.7L Engine (Service Information)) >> Engine Block >> Structural Cover >> Removal >> Structural Cover

Structural Cover

WARNING: This page is about a different variant/trim than selected.
Fig 1: Removing/Installing Structural Cover
GC0003786Courtesy of CHRYSLER LLC
  1. Raise vehicle on hoist.
  2. Remove the left hand exhaust pipe from exhaust manifold.
  3. Loosen the right hand exhaust manifold-to-exhaust pipe retaining bolts.
  4. Remove the eight bolts (1,2,3) retaining structural cover in the sequence shown in illustration.
  5. Pivot the exhaust pipe downward and remove the structural cover.
scientia non olet · About Mike's Workshop Manuals