Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2006 >> Wrangler X, Automatic >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> 42RLE Automatic Transmission (Service Information) >> 42RLE - Service Information >> Input Speed Sensor >> Removal

Input Speed Sensor: Removal

Fig 1: Locating Input Speed, Output Speed and Transmission Range Sensors
GC0009445Courtesy of DAIMLERCHRYSLER CORP.
1 - INPUT SPEED SENSOR
2 - OUTPUT SPEED SENSOR
3 - TRANSMISSION RANGE SENSOR
  1. Raise vehicle.
  2. Place a suitable fluid catch pan under the transmission.
  3. Remove the wiring connector from the input speed sensor. See Fig 1.
    NOTE: The speed sensor bolt has a sealing patch applied from the factory. Be sure to reuse the same bolt.
  4. Remove the bolt holding the input speed sensor to the transmission case.
  5. Remove the input speed sensor from the transmission case.
scientia non olet · About Mike's Workshop Manuals