Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (5.7L Engine (Service Information)) >> Solenoid-MDS >> Installation

Section 2 (5.7L Engine (Service Information)): Solenoid-MDS: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Verify that MDS bores are free of debris, before solenoid installation.
  2. Install MDS solenoid fully into block.
  3. Install hold down bolt and torque to 11 N.m (97 in. lbs.).
  4. Reconnect the MDS wiring harness to the solenoids.
  5. Install the intake manifold. (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - INSTALLATION) .
scientia non olet · About Mike's Workshop Manuals