Rocker Arm: Removal

WARNING: This page is about a different variant/trim than selected.

Fig 1: Cylinder Head Cover Torque Sequence

Courtesy of DAIMLERCHRYSLER CORP.

Remove cylinder head cover. (Refer to ENGINE/CYLINDER HEAD/CYLINDER HEAD COVER(S) - REMOVAL ).

Fig 2: Pushrod Retaining Plate
Courtesy of DAIMLERCHRYSLER CORP.

1 - PUSHROD RETAINING PLATE FASTENER

2 - PUSHROD HOLDER
Install pushrod retaining plate (1)special tool 9070.

Fig 3: Rocker Shaft Torque Sequence
Courtesy of DAIMLERCHRYSLER CORP.
Loosen the rocker shafts using the sequence provided.
CAUTION: The rocker shaft assemblies are not interchangeable between intake and exhaust. The intake rocker arms are marked with an "I".
Remove the rocker shafts. Note location for reassembly.
CAUTION: The longer push rods are for the exhaust side, and the shorter push rods are for intake side.
Remove the pushrods. Note pushrod location for reassembly.

Fig 4: Rocker Arm Retainer Assembly

Courtesy of DAIMLERCHRYSLER CORP.

1 - ASSEMBLY TANG

2 - RETAINER ( FULLY SEATED )

3 - SPACER

4 - ROCKER ARM

CAUTION: Do not remove the retainers from the rocker shaft. The assembly tangs (1) at the bottom of the retainers (2) can be damaged, causing the assembly tangs to break off, and get into the engine.