Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (4.7L Engine (Service Information)) >> Flex Plate >> Installation

Flex Plate: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Flexplate Loosening/Tightening Sequence
GC0003829Courtesy of DAIMLERCHRYSLER CORP.
1 - FLEXPLATE
  1. Position the flexplate onto the crankshaft and install the bolts hand tight.
  2. Tighten the flexplate retaining bolts to 60 N.m (45 ft. lbs.) in the sequence shown.
  3. Install the transmission. (Refer to TRANSMISSION/TRANSAXLE/AUTOMATIC - 45RFE/545RFE - INSTALLATION) .
scientia non olet · About Mike's Workshop Manuals