Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Fuel System) >> Fuel Injection - Diesel >> Sensor-Accelerator Pedal Position >> Removal

Sensor-Accelerator Pedal Position: Removal

WARNING: This page is about a different car, the 2007 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Accelerator Pedal Assembly
GC0039516Courtesy of CHRYSLER LLC
1 - HARNESS CONNECTOR
2 - FASTENERS
3 - ACCELERATOR PEDAL ASSEMBLY
  1. Disconnect the negative battery cable.
  2. Remove the drivers side lower dash board close out panel.
  3. Disconnect the APP sensor electrical connector (1).
  4. Remove the accelerator pedal assembly fasteners (2) and the accelerator pedal assembly (3).
scientia non olet · About Mike's Workshop Manuals