Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (HVAC Systems (Service Information)) >> Controls >> Transducer-A/C Pressure >> Removal

Transducer-A/C Pressure: Removal

WARNING: This page is about a different car, the 2007 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.
Fig 1: Removing/Installing A/C Pressure Transducer
GC0007399Courtesy of CHRYSLER LLC
NOTE: Typical A/C pressure transducer and refrigerant line shown.
  1. Disconnect and isolate the negative battery cable.
  2. Disconnect the wire harness connector (1) from the A/C pressure transducer (2) located on the A/C discharge line (3).
  3. Remove the A/C pressure transducer from the fitting on the A/C discharge line and remove and discard the O-ring seal.
scientia non olet · About Mike's Workshop Manuals