Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (HVAC Systems (Service Information)) >> Controls >> Module-Power-Blower Motor >> Installation

Module-Power-Blower Motor: Installation

WARNING: This page is about a different car, the 2007 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Blower Motor Power Module
GC0028312Courtesy of CHRYSLER LLC
NOTE: LHD model shown. RHD model similar.
  1. Position the blower motor power module (2) into the HVAC housing (4).
  2. Install the two screws (3) that secure the blower motor power module to the HVAC housing. Tighten the screws to 2 N.m (17 in. lbs.).
  3. Connect the two wire harness connectors (1) to the blower motor power module.
  4. On LHD models, install the glove box into the instrument panel. Refer to INSTALLATION .
  5. On RHD models, install the instrument panel silencer onto the passenger side of the instrument panel.
  6. Reconnect the negative battery cable.
scientia non olet · About Mike's Workshop Manuals