Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (HVAC Systems (Service Information)) >> Controls >> Control-A/C-Heater >> Installation

Section 87 (HVAC Systems (Service Information)): Controls: Control-A/C-Heater: Installation

WARNING: This page is about a different car, the 2007 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing A/C Heater Control
GC0028311Courtesy of CHRYSLER LLC
  1. Position the A/C-heater control (4) and the electronic vehicle information center (EVIC) control (3) into the instrument panel center bezel (1).
  2. Install the screws (2) that secure the A/C-heater control and the EVIC control to the center bezel. Tighten the screws to 2 N.m (17 in. lbs.).
  3. Install the center bezel onto the instrument panel. Refer to INSTALLATION .
  4. Reconnect the negative battery cable.
  5. Initiate the Actuator Calibration function using a scan tool (refer to HVAC System Test, found in 24 - HVAC - Electrical Diagnostics).
scientia non olet · About Mike's Workshop Manuals