Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Power Sunroof System (Service Information)) >> Motor/Module-Sunroof >> Standard Procedure >> Sunroof Position Calibration

Sunroof Position Calibration

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Press the power sunroof switch (Open, Closed, and Vent). If no movement occurs when either the open switch or closed switch is pressed, but the system does move when the vent button is pressed and held, the system is not calibrated. Perform the following procedure to position calibrate the power sunroof system.

  1. Turn the ignition to the RUN position.
  2. Press the vent button on the power sunroof switch and hold until the sunroof glass panel has moved to the full vent position and the motor movement has stopped for at least 1 second.
  3. Press the close switch on the power sunroof switch and hold for a moment (at least 100ms) and release. The sunroof glass panel should continue travel to the full close position. If the sunroof glass panel does not return to the full close position, refer to POWER TOP/SUNROOF - ELECTRICAL DIAGNOSIS for full system diagnosis.
  4. Verify proper system operation.
scientia non olet · About Mike's Workshop Manuals