Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Wiper System & Washer System (Service Information)) >> Wiper Module >> Removal

Wiper Module: Removal

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Wiper Module - Removal/Installation
GC0029500Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the battery negative cable.
  2. Remove both front wiper arms from the wiper pivots. (Refer to ELECTRICAL/WIPERS/WASHERS/WIPER ARM - REMOVAL - FRONT) .
  3. Remove the cowl plenum cover/grille panel from over the front wiper module. (Refer to BODY/EXTERIOR/COWL GRILLE - REMOVAL) .
  4. Remove the nut (1) that secures the inboard end of the front wiper module bracket to the stud in the cowl plenum.
  5. Remove the two screws (2) that secure the module bracket to the cowl plenum.
  6. Disconnect the wire harness connector (4) from the connector for the front wiper motor (3).
  7. Remove the wiper module from the cowl plenum.
scientia non olet · About Mike's Workshop Manuals