Intermittent Wipe Mode

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

The following applies to vehicles not equipped with the optional automatic wiper system, or to vehicles equipped with the automatic wiper system that have disabled the feature using the customer programmable features function. When the control knob on the control stalk of the right (wiper) multi-function switch is moved to one of the five DELAY interval positions the SCM sends an electronic wiper switch delay status message to the FCM, then the FCM electronic intermittent wipe logic circuit responds by calculating the correct length of time between wiper sweeps based upon the selected delay interval input.

The FCM monitors the changing state of the wiper motor park switch through a hard wired park switch sense input. This input allows the FCM to determine the proper intervals at which to energize and de-energize the wiper on/off relay to operate the wiper motor intermittently for one low speed cycle at a time.

The FCM logic is also programmed to provide vehicle speed sensitivity to the selected intermittent wipe delay intervals. In order to provide this feature the FCM monitors electronic vehicle speed messages from the Controller Antilock Brake (CAB) and doubles the selected delay interval whenever the vehicle speed is about 16 kilometers-per-hour (10 miles-per-hour) or less.