Sensor-Washer Fluid Level: Installation
WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate a new rubber grommet with clean washer fluid and install it into the washer fluid level switch mounting hole located in the outboard side of the washer reservoir (3).
- Slide the float through and align the barbed nipple of the switch with the rubber grommet seal in the reservoir. The connector receptacle of the switch should be pointed upward.
- Press firmly and evenly on the switch (2) using hand pressure until the barbed nipple is fully seated in the rubber grommet seal in the reservoir.
- Reconnect the headlamp and dash wire harness connector (1) for the washer fluid level switch to the switch connector receptacle.
- Reconnect the front washer hose to the washer pump/motor unit outlet nipple.
- Reinstall the plastic push-in fasteners that secure the left front wheelhouse splash shield to the inner fender panel and the front fascia. (Refer to INTERIOR/EXTERIOR/LINER - INSTALLATION) .
- Lower the vehicle.
- Reconnect the battery negative cable.
- Refill the washer reservoir with the washer fluid drained during removal.