Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (HVAC Systems (Service Information)) >> Distribution >> Motor-Blower >> Installation

Section 25 (HVAC Systems (Service Information)): Distribution: Motor-Blower: Installation

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: LHD model shown in illustration. RHD model similar.
Fig 1: Blower Motor-Removal & Installation
GC0028327Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the blower motor (4) into the HVAC housing (5).
  2. Install the three screws (3) that secure the blower motor to the HVAC housing. Tighten the screws to 2.2 N.m (20 in. lbs.).
  3. Connect the wire harness connector (1) to the blower motor power module or resistor (2), depending on how equipped.
  4. Install the glove box into the instrument panel (Refer to BODY/INSTRUMENT PANEL/GLOVE BOX - INSTALLATION) .
  5. Install the instrument panel silencer onto the passenger side of the instrument panel (Refer to INSTRUMENT PANEL ).
  6. Reconnect the negative battery cable.
scientia non olet · About Mike's Workshop Manuals