Sensor-Brake Fluid Level: Removal

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fluid Level Switch

Courtesy of DAIMLERCHRYSLER CORP.

1 - RESERVOIR

2 - FLUID LEVEL SENSOR

Remove the wire connector from the fluid level sensor (2).

Fig 2: Fluid Level Switch Removal/Installation
Courtesy of DAIMLERCHRYSLER CORP.

1 - FLUID LEVEL SENSOR

2 - RESERVOIR
From the same side of the master cylinder reservoir (2) release the sensor locking taps with a small screw driver.
Pull the sensor (1) out of the reservoir (2) from the connector side of the sensor.