Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Mechanical Brake System - Base (Service Information)) >> Lever >> Installation

Section 19 (Mechanical Brake System - Base (Service Information)): Lever: Installation

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Park Brake Lever & Cable
GC0026835Courtesy of DAIMLERCHRYSLER CORP.
1 - PARK BRAKE LEVER
2 - NUT
3 - CABLE
4 - NUT
  1. Reconnect the wire harness routing clips to the lever.
  2. Reconnect the front cable (3) at the hand brake lever (1).
  3. Install the 3 hand brake lever (1) mounting bolts.
  4. Unlock out the park brake hand lever (1).
  5. Reconnect the park brake switch wire connector.
  6. Check the operation of the parking brake lever (1) and cable (3).
    Fig 2: Center Console
    GC0026840Courtesy of DAIMLERCHRYSLER CORP.
  7. Install the center console (1), (Refer to BODY/INTERIOR/FLOOR CONSOLE - INSTALLATION) .
    Fig 3: Console Rear Cover
    GC0026841Courtesy of DAIMLERCHRYSLER CORP.
  8. Install the rear cover (2) or the DVD player (if equipped).
scientia non olet · About Mike's Workshop Manuals