Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Vehicle Theft Security System - Electrical Diagnostics) >> DTC Troubleshooting >> B1A24-Key Not Programmed >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2007 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. 1) KEY NOT PROGRAMMED 

    Turn the ignition on.

    Using a scan tool, attempt to program the key(s) into the SKREEM.

    Was the programming of the key(s) successful? 

    Yes 

    1. Programming of the key(s) were successful. Test complete.
    2. Perform SKREEM/SKIM VERIFICATION TEST .

    No 

    1. Replace the ignition key and attempt to program it into the SKREEM. If the DTC resets, replace and program the SKREEM in accordance with the Service Information.
      NOTE: If this vehicle is equipped with a Steering Column Lock Module, it must be replaced along with the SKREEM.
    2. Perform SKREEM/SKIM VERIFICATION TEST .
scientia non olet · About Mike's Workshop Manuals