Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Ignition System (Service Information)) >> Relay-Auto Shut Down >> Removal

Relay-Auto Shut Down: Removal

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

The ASD relay is located in the engine compartment within the Power Distribution Center (PDC). Refer to label on PDC cover for relay location.

  1. Remove PDC cover.
  2. Remove relay from PDC.
  3. Check condition of relay terminals and PDC connector terminals for damage or corrosion. Repair if necessary before installing relay.
  4. Check for pin height (pin height should be the same for all terminals within the PDC connector). Repair if necessary before installing relay.
scientia non olet · About Mike's Workshop Manuals