Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (5.7L Engine (Service Information)) >> Engine Block >> Solenoid-MDS >> Installation

Engine Block: Solenoid-MDS: Installation

WARNING: This page is about a different car, the 2007 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: MDS SOLENOIDS
GC0051334Courtesy of CHRYSLER LLC
  1. Verify that MDS bores are free of debris, before solenoid installation.
  2. Install MDS solenoid(s) (3) fully into block.
  3. Install hold down bolt (2) and tighten to 11 N.m (97 in. lbs.).
  4. Reconnect the MDS wiring harness to the solenoid(s) (3).
  5. Install foam insulator pad (1) if removed.
  6. Install the intake manifold. Refer to MANIFOLD - INTAKE .
scientia non olet · About Mike's Workshop Manuals