Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (3.7L Engine (Service Information)) >> Lubrication >> Sensor/Switch-Oil Pressure >> Removal

Sensor/Switch-Oil Pressure: Removal

WARNING: This page is about a different car, the 2007 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Oil Pressure Sending Unit
GC0011823Courtesy of CHRYSLER LLC
  1. Disconnect the negative cable from the battery.
  2. Raise vehicle on hoist.
  3. Remove front splash shield.
  4. Disconnect oil pressure switch connector (4).
  5. Remove the pressure switch (2).
scientia non olet · About Mike's Workshop Manuals