Frame & Bumpers: Fascia-Rear: Installation

Fig 1: Rear Fascia To Wheel Liners & Fasteners

Courtesy of DAIMLERCHRYSLER CORP.

1. Install the park assist sensors, if equipped.
2. Install the energy absorber and install the four push pin fasteners.
3. Position the fascia onto the vehicle and connect the electrical connector.
   Fig 2: LOWER REAR FASCIA & FASTENERS

   Courtesy of DAIMLERCHRYSLER CORP.
4. Install the two push pin fasteners (3).
   Fig 3: REAR FASCIA & FASTENERS

   Courtesy of DAIMLERCHRYSLER CORP.
5. Slightly spread the sides of the fascia to clear the painted surfaces.
6. Direct the slots in the upper sides of the fascia onto the two t-pushpins (4) on either side.
7. Install the two screws (2) and four push pin fasteners (1).
   Fig 4: LOWER REAR FASCIA & FASTENERS

   Courtesy of DAIMLERCHRYSLER CORP.
8. Install the two lower push pin fasteners (3).
   Fig 5: REAR FASCIA TO QUARTER PANEL & FASTENERS

   Courtesy of DAIMLERCHRYSLER CORP.
9. Install the nuts (1) and tighten to 9 N.m (80 in. lbs.).
   Fig 6: Rear Fascia To Wheel Liners & Fasteners

   Courtesy of DAIMLERCHRYSLER CORP.
10. Install new rivets (1) attaching the wheelhouse splash shields (4) to the fascia.