Controller Antilock Brake: Removal
WARNING: This page is about a different car, the 2005 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the negative battery cable from the battery.
- Pull up on the CAB harness connector release and remove connector. See Fig 1.
Courtesy of DAIMLERCHRYSLER CORP.
| 1 - ABS MODULE |
| 2 - ELECTRICAL CONNECTOR |
- Remove the pump connector from the CAB.
- Remove the CAB mounting bolts.
- Remove the CAB from the HCU. See Figure.