Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2004 >> Liberty Limited, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Power Door Lock System & Remote Keyless Entry System) >> Operation >> Remote Keyless Entry (RKE)

Remote Keyless Entry (RKE)

WARNING: This page is about a different car, the 2002 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

  1. LOCK

    Pressing the LOCK button locks all doors, sounds horn (chirp) if enabled, and arms the VTSS, if enabled. The chirp verifies that the RKE receiver has sent a message to the BCM for door lock operation. If a door has not been closed before pressing the LOCK button, the vehicle may not be secured and the VTSS (if equipped) will not arm until the door is closed.

  2. UNLOCK

    Pressing the UNLOCK button once will unlock the driver's door and activate the illuminated entry system and disarm the VTSS, if equipped. Pressing the UNLOCK button twice within 5 seconds will unlock all doors.

  3. TAILGATE

    Pressing the TAILGATE BUTTON unlocks the tailgate remotely and opens the flip-up glass.

  4. PANIC

    Pressing the PANIC button sounds the horns at half second intervals, flashes the exterior lamps, and turns ON the interior lamps. The panic alarm will remain on for 3 minutes, or until the PANIC button is actuated again or the ignition switch is turned to the RUN position. The RKE module is capable of retaining the transmitter Vehicle Access Codes in its memory even after vehicle power has been interrupted.
scientia non olet · About Mike's Workshop Manuals