Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2004 >> Liberty Limited, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Power Door Lock System & Remote Keyless Entry System) >> Component Tests >> Flip-Up Glass Release Switch

Flip-Up Glass Release Switch

WARNING: This page is about a different car, the 2002 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the battery negative cable.
  2. Remove tailgate trim panel. See TAILGATE TRIM PANEL  in REMOVAL & INSTALLATION.
  3. Disconnect the wire harness connector.
  4. Using an ohmmeter, check for continuity between the pins of the wire harness connector while pulling on the tailgate handle.
  5. If no continuity is found, replace the tailgate handle assembly. Refer to TAILGATE EXTERIOR HANDLE in REMOVAL & INSTALLATION.
scientia non olet · About Mike's Workshop Manuals